Built A Cold Air Intake Box Today

[ford_munky_man]

http://www.supermotors.net/getfile/765082/fullsize/100_0568.jpg

http://www.supermotors.net/getfile/765083/fullsize/100_0569.jpg

http://www.supermotors.net/getfile/765084/fullsize/100_0570.jpg

Here is the link to the build thread if interested:
http://fullsizebronco.com/forum/showthread.php?p=2193158#post2193158

In the end it cost me less than $100 to build a custom fitted intake for my 460 Bronco swap, where as I coulda spent 200 or more on one for a 460 that wouldnt work because of it being in a bronco. Kidna neat lol

[Hypoid]

Nice!

Just a few more ideas to mull over, bring that water line up. :)

http://www.naxja.org/forum/showthread.php?t=1006537

[ford_munky_man]

bring that water line up. :)


I may sound Nieve but I am not following...

[Hypoid]

Re-route the fresh air pipe to a higher position and you can get that much deeper before you hydro lock the engine.

[ford_munky_man]

Ah, I was guessing that is what was coming. At this time I have not found another place to route it besides where it is now. which is where the stock 460 intake pipe was at and same as w/ the 351 only on the opposite side. At this time there isnt much water fording going on and really no place that would be that deep around here, so at the moment I am not to worried.

[MirageF150]

Very nice!

[shawns 64 F100]

Nice work mon. :thumbsup: I had togo read the thread to figure out how you made the Ford logo levitate itself over the filter :D

[ford_munky_man]

Thanks for the good comments guys. They are all welcome.

Nice work mon. :thumbsup: I had togo read the thread to figure out how you made the Ford logo levitate itself over the filter :D

Haha I have got that a few times already. Atleast you didnt ask how I made it levitate first! :thumbsup: